Welcome to Buckeye International

support section - Hard Floor Care

for optimal site experience get the latest flash player version here

thanks

quick guide:

Hard Floor Care

Well-maintained entrance mats can capture up to 70% of all the dirt that enters a building.
Always mop or autoscrub a floor prior to burnishing. NEVER burnish a dirty floor.
When stripping a floor, the floor must remain wet while the stripper is allowed dwell time.
When stripping a floor, it is important to tape off areas that you do not want the stripper to touch. A combination of tape and cardboard works well.
On older or unusually worn tile, two coats of 1st Down® are recommended, prior to finish application, to help protect the floor.
Large areas should be stripped in stages to make the job more manageable.
Save leftover stripper to clean the wringer from your finish bucket. This will keep all mop wringers in good condition.
Plastic liners are recommended for your finish bucket because they prevent contaminants from the floor finish
Rayon or rayon blend mops work best for finish application.
To prevent floor finish buildup around the edges, do not apply finish wall-to-wall on every coat. Instead, stay six inches from the wall on intermediate coats.